Low-sodium aluminum hydroxide is an ATH filler option for copper-clad laminate and electronic adhesive formulations with ionic impurity limits. When evaluating Melorim’s SNK-LN series, first check how sodium content is measured, then test how the filler disperses and affects viscosity in the intended formulation.
What to verify in the supplier’s data
Confirm whether the specification reports total sodium or extractable sodium. Before comparing grades, check that the figures refer to the same type of sodium measurement and use the same test method and units. Use the technical data sheet (TDS) to review grade specifications and the certificate of analysis (COA) to verify the results for the lot supplied.
How to compare ATH fillers in a formulation trial
Use the same matrix resin, filler loading and mixing conditions for each candidate. Review particle size distribution, moisture and surface treatment, then compare dispersion and viscosity after adding the filler. Evaluate the finished laminate or adhesive against the project’s acceptance criteria. Record the filler lot and processing conditions so you can repeat the trial with another lot.
When contacting Melorim about SNK-LN, share the intended application, current filler grade, sodium test method and target particle size. These details help identify a suitable grade for sampling.